Heating Repair

Basement furnace installation with new ductwork in the Sequatchie Valley
A central furnace is installed with new metal ductwork in a masonry basement.

No heat in January is an emergency. We prioritize heating-out calls and carry common parts on the truck so we can get you warm again on the first visit whenever possible.

What we fix

  • Gas furnaces that will not ignite or keep going out
  • Heat pumps stuck in defrost mode or blowing cold air
  • Auxiliary strip heat running when it should not
  • Mini-splits that will not heat
  • Thermostat issues, wiring problems, and control-board failures
  • Weak airflow, loud operation, and hot or cold spots
  • System that runs constantly without keeping up
  • Cracked heat exchangers and other safety issues

Honest answers on repair vs. replace

A failing heat exchanger, a compressor near end of life, or a refrigerant type that is no longer sold can push a system toward replacement. But a lot of no-heat calls are a bad flame sensor, a stuck contactor, a bad capacitor, or a control board fault. Those we fix, we do not sell a new system over them.

Safety first

If we smell gas, see a cracked heat exchanger, or find carbon monoxide risk, we shut the system down and tell you before we do anything else. That is a small enough part of the calls we run that it is worth flagging when it happens.

Serving Sequatchie Valley, Cumberland Plateau, Chattanooga area, and the tri-state line.

Recent work

Related pages

Call Kilgore Heating and Air at (423) 637-1846. Sheddie usually answers the phone.